To coat new bare timber immediately, scrub damp timber with Cabot’s New Timber Prep, following label instructions.

New Timber Prep will draw out tannins and oils quickly from the surface, allowing you to skip the 4-6 weeks weathering process required for new timber.

Remove back to bare timber using a paint stripper, or sanding.

For exterior surfaces clean with Cabot’s Deck Clean following label instructions.

For exterior surfaces clean with Cabot’s Deck Clean following label instructions, then allow timber to fully dry. Test if the surface is ready for coating by sprinkling water on the timber. If the water beads on the surface, repeat the application of Cabot’s Deck Clean. If water is absorbed into timber, it is ready for coating. For a more transparent look, sand timber back to bare before coating.

For best results, sand timber back to fresh substrate. Clean with Cabot’s Deck Clean following label instructions.

Application:

1. Stir thoroughly with a broad flat paddle before and during use.
2. Using a brush, apply liberally along the length of the timber including exposed edges and end grain. 
3. Apply two coats allowing 2 hours between coats.

Every 12 months check your coated timber for changes in colour or water repellency diminishes due to weathering. When required.