Cabot's Cabothane Clear Water Based
Zoom
Cabot's Cabothane Clear Water Based is a durable water based polyurethane, for use on all interior timber including for doors, windows, trim and furniture. This clear polyurethane varnish is quick and easy to use, with a 2 hour recoat time. It protects your timber from the wear and tear of everyday life, and is won't yellow over time. Hard wearing, non-yellowing. This versatile product also acts as a clear topcoat over Cabot's Interior Stain Water Based.
| Areas |
|
|---|---|
| Sizes |
|
| Application |
Brush
Spray
|
| Touch Dry |
30 minutes
|
| Re-coat |
2 hours
|
| Coverage |
16 m2/L |
| Cleaning |
Water
|
Hot tip!
Hot tip!
Sand the surface smooth using 180 - 240 grit sandpaper. Sand only in the direction of the grain. Remove all traces of sanding dust.
To coat new bare timber immediately, scrub damp timber with Cabot’s New Timber Prep, following label instructions. New Timber Prep will draw out tannins and oils quickly from the surface, allowing you to skip the 4-6 weeks weathering process required for new timber. Always follow New Timber Prep with Cabot’s Deck Clean following label instructions.
- Thoroughly clean the surface with Cabot's Floor Clean and allow to dry.
- Apply one coat to a small test area. Allow to dry for 3 hours. Press sticky tape firmly to the surface and pull off quickly. If the coating comes off, sand back further to a sound surface. Previously Coated Exterior Timber For best results, remove back to bare timber using a paint stripper, or sanding. For exterior surfaces only, clean with Cabot's Deck Clean following label instructions.
How to stain Your Interior Timber Furniture
Brush, Spray
Hot tip!
- Stir thoroughly with a broad flat paddle before and during use.
- Apply with a good quality brush or spray gun. If spraying, back brushing is recommended. If brushing, always brush in the direction of the grain.
- Allow to dry for a minimum of 2 hours. For best results, lightly sand to remove any grain raise using 240 grit paper. Remove all sanding dust.
- Apply 2nd & 3rd coats as above.
Once the surface becomes excessively scratched and worn, it's time for a re coat.
1. Thoroughly clean the surface with Cabot's Floor Clean and allow to dry.
2. Apply one coat to a small test area. Allow to dry for 3 hours. Press sticky tape firmly to the surface and pull off quickly. If the coating comes off, sand back further to a sound surface.
Cabot's Cabothane Clear Water Based
No sanding required
High durability
Fast recoat
Low odour & non yellowing
Select colour range
Colour - Clear coat
Sheen - Satin
Timber type - Untreated Pine
Cabot's Cabothane Clear Water Based
Calculate total usage
If you are unsure how much product you need, please use our product calculator. Please note minimum length/width is 1 metre and maximum is 50 metres.